And, Ihad just the problem you described with twitchy steering on a landing rollout. due to the very narrow track of the main gear. my Yellow F-15 is a bit touchy on the ground, even with very low rates. I've not had the problem you mentioned with my warbirds (who stay with the tail flying till they are very slow) or with my R54 jet (very wide main gear). This is great for tight maneuvers and doesn't cause any problem during takeoffs and landings. So the throw is still exponential with about 30 degree each way but once the stick reaches its maximum position, all the available throw is used in one big step. One last other optional great thing is to setup a mix to give as much throw as available when full left or full right is given. You can also force the steering to be straight before the retraction occurs. Optionally, setup a mix to disable the steering once the gear is retracted. If the plane is still unstable during the takeoff roll, I use a cheap gyro with about 50% gain. I use 80% of expo on the steering and about 30 degrees each side I use a different channel on the same rudder stick such as the steering is completely different from the rudder Here is what works for me (all learned here on this forum) I suspect this will make your takeoffs harder. The owner Ryan was present and did little to make right no offer of delivery, no inconvenience discount, no apology but did receive one from his associate Francisco who was great! Not sure if I’d go for the great prices again over getting the run around and many trips from Vallejo to their store.I'm concerned about using servo slow for and directional control. This is now our third trip without all of our materials and had me return Friday. The associate said that they were coming from their Oakland shop and would be here tomorrow (Wednesday.) Now I call to confirm the pieces have arrived to which the associate said yes so we go back up on Wednesday for final pick up. Went on Tuesday for pick up and got all the materials except the original missing pieces that delayed our Friday pick up. Fine, we’ll be back Tuesday to which they agreed. Came in on Friday & paid in full and placed an order, they said they couldn’t load that day due to missing pieces of one set of tiles. Great products and great prices but their inventory needs work, without a doubt. Sharing my experience and a couple of pictures of some of the damages in hopes that others won't have to go through what I did. They didn't offer an apology nor discount. A contractor might over look damages because they might be able to cover it up or repair. but you see i bought the cabinets for my home not as a contractor. This is not an assumption, this is exactly what i was told. They didn't even apologize because to them this is normal. They offered to swap out the cabinets with ot her cabinets of the same type but those were even more damaged than the first ones they brought out. Sure they are cheaper than other stores such as home depot but at least at home depot they won't tell you that brand new cabinets are normally damaged and that once they are installed you won't be able to see the cracked. I mean they were brand new, who would expect 50% of the cabinets to have damaged wood and horrible paint job. I was shocked to see the cabinets damaged. I went to pick up the cabinets I had ordered.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |